How To Tie A Trilene Knot
I use the Trilene knot to tie hooks and lures to fluorocarbon or monofilament line.
Take the line and go through the hook eye, pulling out about an 8 to 10 inch tag.
Now, go around and back through the hook eye, pulling out about 8 to 10 inches of tag, this creates a loop around your index finger.
Take the tag and wrap it 4 to 10 times around the main line.
Find what works best for you. Once the wraps are finished, take the tag and put it through the loops were your index finger was.
Time to lubricate your knot. The best way, is to run the knot through your mouth and use saliva.
After the line has been lubricated, It’s time to cinch up the knot.
I found with this knot, holding the tag in my teeth, while holding the lure or hook and pulling on the main line works best.
After cinching up using your teeth. You may need to cinch up a bit more using your thumb and index finger, pinching just above the knot while pulling on the main line until the knot is nice and tight, repeat if necessary.
Now trim the tag a little less then a quarter inch.
You just learned, how to tie a trilene knot.